• Clip-on housing for "top-hat" DIN rails
• 3-point or 3-point stepping control for thermocouples and Pt 100 input
• Start-up circuit for hot-runners
• Stand-by function
• Heating current monitor
• CANbus / CANopen, PROFIBUS-DP, RS 422/485
• Interface for PC, Engineering Tool or operating terminal BT 800

Following CANbus and PROFIBUS-DP , the successful KS 800 is now available in a version for Device-Net . Furthermore, the controller can now be supplied with 8 additional analog outputs. This allows analog actuators to be controlled with a 0...20mA (0...10V) signal, so that heating or cooling devices with a continous input can be connected directly.
In addition, the function "water cooling" (evaporation principle) is included as standard.
Unused digital inputs/outputs of the controller can also be addressed directly by the central PLC system.
Via a freely configurable process data module and the Engineering Tool, data can be defined for transmission on the PROFIBUS-DP link. With CANbus and the LMT service, the KS 800-CAN can be addressed via its serial number, thus allowing individual identification e.g. of transmission speed and node address.